Enabling of RAW mode in Olympus C-7xx series cameras

DISCLAIMER:

THE PROGRAM IS PROVIDED "AS IS", WITHOUT A WARRANTY OF ANY KIND.
IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DAMAGE CAUSED BY
USE OF THIS PROGRAM.
YOU MAY NOT USE THIS PROGRAM OR ITS PARTS FOR COMMERCIAL PURPOSES
WITHOUT AUTHOR'S PERMISSION.

How to use:

  1. Put camera in "CONTROL" mode (instructions for "CONTROL" mode are here).
  2. Connect camera to PC.
  3. Launch OlyRAW.exe.

            If you see the following screen:

           it means your camera is in "STORAGE" mode, so you have to repeat the step 1.

            If you see the following screen:

            it means your camera is not connected to PC, so you have to repeat the step 2.

           If you see the following screen:

            you can proceed with step 4.

  1. Check the box "RAW enabled" and press "خت", within a couple of seconds you'll see the following screen:

     

            If you do not see the above screen, something went wrong. Try to repeat the procedure from the beginning.

  1. Exit program, disconnect camera from PC. If the camera hangs up (it may happen), just take out and re-insert the accumulator.

  2. Return camera to "STORAGE" mode.

  3. DisablingRAW mode is performed with the same procedure (see steps 1-3).

  4. Uncheck the box "RAW enabled" and press "خت", within a couple of seconds you'll see the following screen:

     

  1. Exit program, disconnect camera from PC, swith on "STORAGE" mode.

 

If you have any problems or comments, please .

Special thanks to:

- for cpixraw source and info placed at e2500.narod.ru.

- for assistance in firmware and RAW analyse and for beta-testing.

- for beta-testing and this manual.

- for countenance and possible support.